I'm Battin 1000

[Mastermind]

The hits just keep on comin. Who has had this happen before?

Brand new 12.00 bit.

 

[Canadian farm boy]

That’s a new one. Never seen that before. I’ve seen the cutters chipped and I’ve bent my fair share of burrs but never actually snapped one quite like that.
You’ve got some skills sir.

 

[andyshine77]

Never in a cylinder, but a few times in steel.

 

[Mastermind]

That’s a new one. Never seen that before. I’ve seen the cutters chipped and I’ve bent my fair share of burrs but never actually snapped one quite like that.
You’ve got some skills sir.

I'm a professional.

 

[Basher]

C&C Speciality?

 

[Mastermind]

C&C Speciality?

Not the burr. Buckeye Carbide

 

[TreeLife]

Geeze, Randy...really having some poor luck. Sorry to see that, keep your head up!

 

[jacob j.]

You'd think those Laotian schoolchildren would be getting their act together by now.

 

[Armbru84]

Not the burr. Buckeye Carbide

Ever run them longer ones I sent ya awhile back?

 

[Basher]

Not the burr. Buckeye Carbide

Difficult to trust tooling these days, who knows where its made. I busted a scaling bit clean off its shaft, a 3/4" hex shaft Hilti, never seen one snap straight and clean across evah!

 

[Brush Ape]

You'd think those Laotian schoolchildren would be getting their act together by now.

Their shackles was made here but damn chains from china....

 

[Mastermind]

Ever run them longer ones I sent ya awhile back?

Run em? Wore em out. Best burrs I've ever used.

 

[Armbru84]

Run em? Wore em out. Best burrs I've ever used.

https://mbemrocatalog.com/product-mastercut-tool-5514-se51fm.html

Thats those in the normal short version...almost $5 cheaper than that buckeye burr. issue is you have to get 8 to get over their min order qty. made in the USA!

 

[dustinwilt68]

Musta been a husky cylinder.lmao

 

[Wilhelm]

Too hard or bad mixture raw carbide material ended in production of those bits?!

The cutting edges seem to be chipped too.

It may be a bad production batch if You have more of them snap like that.

 

[Mastermind]

https://mbemrocatalog.com/product-mastercut-tool-5514-se51fm.html

Thats those in the normal short version...almost $5 cheaper than that buckeye burr. issue is you have to get 8 to get over their min order qty. made in the USA!

Thank you for the link Cole. I'll be ordering some.

 

[Mastermind]

Musta been a husky cylinder.lmao

It twas.

 

[Mastermind]

Too hard or bad mixture raw carbide material ended in production of those bits?!

The cutting edges seem to be chipped too.

It may be a bad production batch if You have more of them snap like that.

This one is the only one ever. I'll be seeking a refund, or replacement.

 

[srcarr52]

This one is the only one ever. I'll be seeking a refund, or replacement.

Send it back and ask them to sharpen it, lol!

 

[Mastermind]

Send it back and ask them to sharpen it, lol!

That would be hilarious.