Farmertec G372XP Pro

[cuinrearview]

The difference could be aluminium in the chicom vs magnesium in the swedish?

The China pro saws are made out of carbon fiber.

 

[White Mountain Saws]

The China pro saws are made out of carbon fiber.

Sure are. Plastic with a hydro dipped carbon fiber pattern.

 

[cuinrearview]

Sure are. Plastic with a hydro dipped carbon fiber pattern.

I'm not sure yet which of your posts I find funniest. Please, keep going.

 

[White Mountain Saws]

I’m SOL on the 371 tag.

Anyone have any suggestions how long the bottom end last on these clone saws?

 

[cuinrearview]

I’m SOL on the 371 tag.

Anyone have any suggestions how long the bottom end last on these clone saws?

Nope. Until they blow. All of them. Maybe next week, maybe next decade. That's the fun of them.

 

[White Mountain Saws]

Soon to be installing a used OEM coil to see if there is a difference between aftermarket and OEM coils.

Replaced the fuel hose and impulse hose with OEM lines. The screws holding the starter pawls are embarrassing.

The little inconsistencies on this saw are a PITA. I noticed the carb wasn’t functioning to full throttle. Turns out the carb has to be pushed up, the throttle cable holder has to be pushed down, while tightening the carb bolts. Otherwise 7/8ths throttle is what you get. Luckily I found such before digging in to replace the throttle cable.

 

[farminkarman]

Soon to be installing a used OEM coil to see if there is a difference between aftermarket and OEM coils.

Replaced the fuel hose and impulse hose with OEM lines. The screws holding the starter pawls are embarrassing.

The little inconsistencies on this saw are a PITA. I noticed the carb wasn’t functioning to full throttle. Turns out the carb has to be pushed up, the throttle cable holder has to be pushed down, while tightening the carb bolts. Otherwise 7/8ths throttle is what you get. Luckily I found such before digging in to replace the throttle cable.

I can’t speak for the “pro” models, but PITA pretty much sums up Farmertec chainsaws.

 

[redline4]

I say one should bolt a few lasers, extra handles and flashlights to it so it can be Pro Tactical.

 

[huskihl]

I say one should bolt a few lasers, extra handles and flashlights to it so it can be Pro Tactical.

Useful trinkets

 

[White Mountain Saws]

I installed a used Husqvarna 350 OEM coil (changed the lead) and gained roughly 1,200 RPM at idle. I reset idle by backing the idle adjustment out. The L needle was/is set in a good position. Idles around 2600-2800. I removed a 1/8 turn of fuel out of the H needle. Top RPM is set at 14,000 now.

Aftermarket coils seem to have a different spark curve at the expense of engine performance. Carb adjustment is easier now having the OEM coil and, throttle response is better.

 

[White Mountain Saws]

Performance increased after adding this sticker.

 

[Maintenance Chief]

Unfortunately thats not the right sticker for "EXTRA PERFORMANCE " its this one.