High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

ChainBrake tool Husqvarna

rkious

OPE Member
Local time
1:17 PM
User ID
2692
Joined
Feb 24, 2017
Messages
44
Reaction score
8
Location
JONESBORO AR
Looks like taking a Flat screw driver and cutting a slot in the center would work for putting the chainbrake spring back in( Husqvarna) . Just using a Normal screw driver at this time .... Do y'all use the factory tool or build your own?

Thanks,

Ross
 

Warped5

Pinnacle OPE Member
Local time
1:17 PM
User ID
432
Joined
Jan 7, 2016
Messages
977
Reaction score
2,733
Location
Northwest IN
Country flag
I put a large screwdriver in the vise, grab the clutch cover and put the screwdriver tip in that 'square' hole. Then gently twist the cover until the brake is reset.

Plan B is putting vise-grips on to act as the brake flag and reset it that way.
 

AVB

Super OPE Member
Local time
1:17 PM
User ID
1240
Joined
May 4, 2016
Messages
681
Reaction score
712
Location
Elora, TN
Country flag
The OP was wanting how install the large chain brake spring. You can modified a cheap opened wrench to push the spring back on with the cover being held in a vise. As resetting the chain brake knee joint a modified 13mm/1/2" scwrench will work nicely although you will need an extra extension on it as they are to short and require too much hand torque to work.
 

rkious

OPE Member
Local time
1:17 PM
User ID
2692
Joined
Feb 24, 2017
Messages
44
Reaction score
8
Location
JONESBORO AR
Thanks . I am going to play around with a few old wrench's and screwdrivers and modify them and see what ends up being the best. As far as resetting the chainbrake I just use the Brake handle as a tool to reset it with , but cutting out a socket might be the way to go.
 
Top