- I could Kiss you!
They Pull In The Cut if They Are Tuned and Chained Properly
They Pull In The Cut if They Are Tuned and Chained Properly
Bob Mcculloch was very ahead of his time in Fact the bigger saws in the Husky Line used Bob's Port Timing magic because of Electrolux acquisitions leaving Husqvarna to gobble up their Competition and glean their technology to improve the Husqvarna line of saws. (they have done a good job i think personally) so getting a bigger Bore Mac jsut makes sense to me because i want to see how well we can make it run and give the saw a new life- I like Yellow saws. i hope to become a loyal fan worthy of running that fine name of saws!
blessings and Aloha td
250 could end up being *WALKERIZED* and run a bit faster as well as mounting a .025 sprocket bar chain setup for a lower load on the saw
BBRS has some real nice Macs that have been ported and massaged- i hear the 805 was decent later variant but alas it is only 82ccs i could live with that i think if the rpms are right after a Mod Job ....we desire the Pro Mac 1000 variant and or a 840 940 895 etc etc etc-very nice! and there are a few others in the lineup i have my eyes upon!
That super 250 should go well above 6000 rpm. Under a heavy load with a long bar the reeds will fully open, if properly setup, and it will be as though the saw received a shot of nitrous. It should start to scream and really pull hard at a much higher rpm than the other 87, 95, and 99cc saws do. The super 250 is a factory ported hotrod, though with a silly 20" bar, most will never experience what THAT saw really is.
NO!!! The regular 250 and super 250 do not behave the same at all. It's like comparing a stock 41 super against a ported 046 or ported 461.
1st place at the saw race Bob Mculloch thank you!
Im So Down to Run a Super 250!!!!!!!!!!!!!!!!!!!!!! Bring It On!!!!!!!!!!!!!!!!!!!!
so how do we purchase a few of those fine Machines??????? just let us know paypal is warmed up
i will take a few of Those Macs off yer Hands- yesterday! thats if it's the right saws for the right priceI have a friend that is wanting to sell off his homelite collection. There is probably at least 80-90 saws available most of which are complete. From what I know is he has a 1130g, 750, 550, couple 80s? And some Wiz? Saws. He wants to sell them all. Make an offer, he is hoping to get around $4,500. He lives around Omaha Nebraska. Attached are a few photos if you are serious I’ll be there again in a week or so and can get more specific photos of what saws you want to see. Pm me for more details.
Sent from my iPhone using Tapatalk
