HELP! Big cylinder bolt spacing measurements

[Powerstroke Cowboy]

I broke down and popped the cylinder off the clone 880. For the betterment of the thread and overall forum data base. The cylinder bolt spacing is.

59mm clutch to flywheel and 60mm intake to exhaust.

 

[Shane¹]

Anyone have bolt spacing on 084 cylinder is it smaller than 880? Has anyone tried one of the dukes 880 cylinders if so how are they holding up? @Duke Thieroff

 

[Duke Thieroff]

Anyone have bolt spacing on 084 cylinder is it smaller than 880? Has anyone tried one of the dukes 880 cylinders if so how are they holding up? @Duke Thieroff

I'll try to check tomorrow, if I remember, on the bolt spacing. Tuesdays are busy for us.

The 084 cylinders are really nice, the 880s "aren't bad" but there's only limited factories to buy that specific model from.

 

[Shane¹]

Since I am trying to do a hybrid option I think whatever bolt spacing is better will probably be what I start with

 

[Ketchup]

What is the spacing for 9000?

 

[Shane¹]

9000 is 54mm side to side and 52mm intake to exhaust

 

[Shane¹]

I'll try to check tomorrow, if I remember, on the bolt spacing. Tuesdays are busy for us.

The 084 cylinders are really nice, the 880s "aren't bad" but there's only limited factories to buy that specific model from.

Did you happen to have a chance to check spacing on the 084 cylinder yesterday?

 

[Shane¹]

Bump anyone have an 084 cylinder or base gasket around for quick measure

 

[Shane¹]

Bump any other big cylinders out there

 

[Ketchup]

 

[thedude74]

Bump any other big cylinders out there

Husky 2100CD
Side to side OD 66.2mm


Side to side ID 53.4mm

 

[thedude74]

Husky 2100CD
Front to back ID
Front to back OD

 

[thedude74]

Husky 2100CD
Squish band to cylinder base 74.29mm

It's 89.05 mm...Moved a hair while taking photo one handed.

 

[Shane¹]

Does anyone happen to have measurements of a Husqvarna k1270 piston?

 

[Ketchup]

@Shane¹ , what’s the bore height on the 9000 jug?

 

[Shane¹]

@Shane¹ , what’s the bore height on the 9000 jug?

I have not took one off yet been working off a spare bottom end so far