High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

346xp tank vent

redoakneck

Pinnacle OPE Member
Local time
8:14 PM
User ID
620
Joined
Jan 20, 2016
Messages
878
Reaction score
1,991
Location
Ohio326
Does the white plastic piece with the gauze in it just push down in that hole?? or is there a tube??

Put some tiny o rings on the white piece and push it in???


Had a hose attached to it, not sure how its supposed to stay in if that is what goes in the hole??
 

Gary Courtney

Pinnacle OPE Member
Local time
7:14 PM
User ID
413
Joined
Jan 5, 2016
Messages
1,002
Reaction score
2,472
Location
Froglevel
Country flag
iplimage.php
 
Last edited:

P.M.P.

Stiff Member
Local time
8:14 PM
User ID
352
Joined
Dec 31, 2015
Messages
12,226
Reaction score
58,755
Location
Michigan
Country flag
The tank vent does have a hose that attaches to it and goes up through the carb floor to the carb.The vent pushes into the tank is all.
 

Gary Courtney

Pinnacle OPE Member
Local time
7:14 PM
User ID
413
Joined
Jan 5, 2016
Messages
1,002
Reaction score
2,472
Location
Froglevel
Country flag
mine does not have hose on it and it runs fine but this is where it goes
 

Gary Courtney

Pinnacle OPE Member
Local time
7:14 PM
User ID
413
Joined
Jan 5, 2016
Messages
1,002
Reaction score
2,472
Location
Froglevel
Country flag
I have one 346 that has a white tank vent and the a little plastic nipple next to it that has a return from primer and my other just has white vent
 

P.M.P.

Stiff Member
Local time
8:14 PM
User ID
352
Joined
Dec 31, 2015
Messages
12,226
Reaction score
58,755
Location
Michigan
Country flag
I have modded the tank vent on mine as well as a 357 which is the same.Heres a pic used the bailing wire to push it all out and then discarded the 2 pieces on the right.Then just push the gray looking cork back in.Also put a hole angled down in the tank in behind where the vent fits in recess.

NCM_0555.JPG

NCM_0559.JPG
 

redoakneck

Pinnacle OPE Member
Local time
8:14 PM
User ID
620
Joined
Jan 20, 2016
Messages
878
Reaction score
1,991
Location
Ohio326
Ok, thanks. Trying to put a 357 intake on the 346, this should help.

Any other tips??? The 357 doesn't have a nipple on the air filter / carb plastic connector.
 

redoakneck

Pinnacle OPE Member
Local time
8:14 PM
User ID
620
Joined
Jan 20, 2016
Messages
878
Reaction score
1,991
Location
Ohio326
So drill the angled hole where the white plastic piece pushes in, push white (after gutting) piece in with nipple pointing out , then hook up a hose. Since no nipple on 357, just leave end of hose in carb box???
 

mdavlee

Hillbilly grinder
Local time
8:14 PM
User ID
279
Joined
Dec 28, 2015
Messages
14,194
Reaction score
64,608
Location
TN
Country flag
If I remember right I drilled one on an angle beside the original hole.
 
Top