SELLING 2166/72 new take off parts

[MG2186]

Piston,cylinder,coil,top cover minus air filter cover $125 shipper OBO

 

[davidwyby]

Snooping around the forum researching...did you go OE?

 

[MG2186]

Snooping around the forum researching...did you go OE?

Yes I did, put a 51.4 top end on one and a 50mm on my brother's

 

[davidwyby]

Hm, I'm on the fence on whether to stick with XT NE or go OE. Have appt with huskihl.

 

[huskihl]

Hm, I'm on the fence on whether to stick with XT NE or go OE. Have appt with huskihl.

I’ve got all the parts in stock if you want to go the oe 50 or 51.4 route

 

[davidwyby]

I’ve got all the parts in stock if you want to go the oe 50 or 51.4 route

I would imagine OE or XT make about the same power and it comes down to preference for simplicity and parts availability or not?

 

[Funky sawman]

I would imagine OE or XT make about the same power and it comes down to preference for simplicity and parts availability or not?

I personally like the single ring 50 mm version, best runner out of them all

 

[huskihl]

I would imagine OE or XT make about the same power and it comes down to preference for simplicity and parts availability or not?

The 51.4 runs the strongest when ported for me. The 50 ends up being a little higher strung and the Xtorq ends up with a flatter torque curve