husquvarna

Hey everyone it’s been awhile since I’ve been back on here so I’m hoping I’m posting in the correct spot. I have a Stihl ms 362. The saws compression wasnt in good shape, I took it apart and the plating on the intake side was completely worn off. I replaced piston and cylinder, piston rings...

Hi all, I've reading and reading for weeks about sprucing up my 3120 (non EPA) I've collected all the bits I believe I need. Now I could just dow with some help putting it into action. The saw will mostly be used for milling, but occasionally felling/cross cutting of oversized stems. Milling...

This build is for a good friend of mine. Not completely sure on the cylinder just yet, but it's going to be a 272. I have all the other parts ready. If you are interested in checking out a direct comparison of a 272 Hyway Titanikel p&c and a 272 OEM cylinder p&c, check out my other thread -...

Had a 550xpg come back in locked up, seamed odd for the amount of use it saw. Upon disassembly it was discovered that a tiny screw had found its way into the cylinder. You can see it as I found it in this picture. It took a little bit of detective work to find where it came from. I...

Looking for an air injection model 254. Looking for mostly case with out without crank

Looking for a service manual please or advice on removing the threaded drive shaft from the clutch drum. Thanks in advance.

Looking for a service manual please. Or advice on removing the threaded drive shaft from the clutch drum. Thanks in advance.