ZERO's latest activity
-
ZERO reacted to SawAddictedFarmer's post in the thread Stihl oiler upgrades. Please post compatible saws and oilers. with
Like.
@Da dog man any luck getting a oiler? -
ZERO reacted to davidwyby's post in the thread 372 sputters when tipped, passes spray test with Like.
Flexible, intermittent annoying confusing obnoxious
-
Flexible, meaning something that can change size depending on throttle position. There’s vacuum inside the crank case and intake boot...
-
ZERO reacted to Junk Meister's post in the thread 372 sputters when tipped, passes spray test with Like.
You aren't walking on water - yer hydroplaning with this troubleshooting analysis. If'ns I keep reading "STUFF" like this I will either...
-
I put a light film of motoseal on all those contact points Never had a leak.
-
Either. I’ve worked on way more xt’s though.
-
ZERO reacted to davidwyby's post in the thread 372 sputters when tipped, passes spray test with Like.
Xp or xt?
-
Interesting. From my experience, those carburetors have held up very well. I’ve worked on many a 372 and Ican’t recall even rebuilding...
-
ZERO reacted to davidwyby's post in the thread 372 sputters when tipped, passes spray test with Like.
I swapped the carb to a 385 carb off my smashed XS 2175 this am and I haven’t put a bar on and put it in wood yet but the tune is stable...
-
Put video of this shelf queen on yt.
-
ZERO reacted to Woodslasher's post in the thread 372 sputters when tipped, passes spray test with Like.
Out of 5 or more 372-chassis saws I've stripped only 1 had an o-ring present and none of the ones without it exhibited any sort of...
-
Yes the seal will be leaking, but chain tension will have a lot more to do with crankshaft position than saw orientation will. They do...
-
Something else I’ve learned along the way. If your carb screws are normally at one and one, turn the H out 2 turns. Hold the saw wide...
-
026 failing the tip test is more likely fuel pooling in the intake and in the lower transfer ports. L screw needs to be leaned out a...
-
ZERO reacted to Junk Meister's post in the thread 372 sputters when tipped, passes spray test with Like.
If this then won't the seal most likely be the culprit. The Pocket brg movement caused the Seal issue. Sihl 026 failing the tip test...