Woodslasher's latest activity
-
Woodslasher reacted to jacob j.'s post in the thread Husqvarna Lawn Tractor Detailed Wiring Diagram with
Like.
I scanned the file with antivirus/malware software and it's safe. -
Shrinking an aftermarket 460 3/4 wrap for my 026. 3/4" out of the width, need to drop the top about an inch. Good TIG practice anyway.
-
Woodslasher reacted to hacskaroly's post in the thread MCCULLOCH The official McCulloch thread with Like.
Here is the negative of a Husky 365/372 case gasket I cut with the Cricut: Here a test run of a carb gasket for the Prentice-Reed...
-
Woodslasher reacted to hacskaroly's post in the thread MCCULLOCH The official McCulloch thread with Like.
I draw them out in Adobe Fusion and then use my wife's Cricut to cut them out. Nice crisp edges, much better than what I get trying to...
-
Echo 9010 blower that I was replacing a crankshaft bearing on and decided to fix the wonky exhaust and transfers. No lathe work or BGD...
-
-
The owner of this forum had Randy port a 660 to have an Asian company cast it. Worked for a few copies but after a few months of...
-
Since we're talking about porting, doesn't it seem obvious I'm talking about the cylinder?
-
Not unlike online recipes. All you want is ingredients, time, temperature, prep and gotta suffer boring stories about their boring lives.
-
Not long ago, I was looking for tips on fixing bar oil leaks. One video in particular, the guy talked for about a minute, then spent a...
-
I think I have some form of retardation where I can't pay attention to stupid sh!t for more than 30 seconds. The only time I click on a...
-
You get it. People need made fun of again. It's a character builder.
-
Redid the muffler on my ported MS460. Of note-I went through with a round file and cleaned up my edges-I am not a savage. I just didn’t...
-
-
The 26LCS shown above has found a new home in Oregon... Today I have an SEZ on the bench, 160 PSI compression and a snappy blue spark...
