what does the extra fuel -vent line go to on the e-torque ? it goes into a green elbow near top of tank =also there are 2 small orange nipples to the right of intake ? does it go to one of them ? if so which one?
no pop up , I didn't check port timing , maybe I will take a look, one thing I did notice the exhaust port was larger than normal width , I fit the gasket to port then to muffler had to trim a lot more off sides of both than normal.
I have built 3 of these saws 1 for my son 1 for a friend both were stock and run well , then I built me one with a hyway 56 mm BB cylinder, when I measured squish without a gasket it was .019 so I went with that , the 2 stock saws had enough compression that if you failed to reset the de-comp...
thanks , getting the tank off was tough with the oiler and choke rods in the way of the av mounts there has to be a better way to re install ? and where could I find seals and a pulse tube -google ?
I got it apart today the piston is heavily scored on exhaust side but looks great on intake side, on the exhaust side of cylinder above exhaust port it feels better than it looks , if I try I can just barely feel 1 spot that my 90 pick cand
feel & catch on a bit -I have a piston coming -I cant...
when I got it the plug wire was off and the throttle was stuck wide open …...looking through exhaust port the piston looks pretty scored and the rings appear to be stuck , Im hoping a piston will fix it I found a new old stock piston with rings ill know more next time I get to work on it when...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.