Wilhelm's latest activity
-
I'm weighing up whether to get the oil pump repair kit and the oil pump drive or a whole oil pump with drive to save shipping from... -
Wilhelm replied to the thread KUDOS Dolmar 7900 heated handle wiring.No clue. I have 2 "H" Dolmar's and don't use them. :rolleyes: Also, neither is a large frame gal.
-
I think I have it figured out thanks for all the help gentlemen! Goes from generator to switch, switch to tank heater, tank heater runs...
-
There should be some stanchions cast into the flywheel side of the case where the generator mounts for starting the wiring. It looks...
-
Wilhelm reacted to hacskaroly's post in the thread KUDOS Dolmar 7900 heated handle wiring with
Like.
@Wilhelm do you have any information for this? Not sure how close it is to a Husqvarna, but on my 272, it starts at the generator... -
Does anyone have a diagram of how the wiring goes on a 7900 heated handle saw? Got most of the heated pieces I think just got to figure...
-
Wilhelm replied to the thread Dolmar PS-7300 oiling rate.Whole pump will be quite pricey. I'd try find a repair kit and drive from the same seller. If You think Your saws clutch springs are...
-
Wilhelm reacted to hacskaroly's post in the thread Presets for Spinning and Breaking Chain with Like.
I will take a look, a few years ago the store I worked for was getting rid of everything they did'nt want/need where they could, so...
-
Wilhelm reacted to hacskaroly's post in the thread Presets for Spinning and Breaking Chain with Like.
Ok, the one micrometer on my workbench has dead batteries and the other one is MIA. I will just go ahead and send them to you, I have 18...
-
Wilhelm reacted to hacskaroly's post in the thread Presets for Spinning and Breaking Chain with Like.
I might have some, what is the ID size you are looking for so I can double check?
-
If you don't spend the night in the county jail, you are welcome to spend the night in the museum. Mark
-
Eggshooter proved that a few years ago. Put several different oils onto a piece of shiny steel and set them on a shelf for a year in his...
-
Wilhelm replied to the thread Vintage Chainsaw Museum.Tourist guide: 1) visit chainsaw museum 2) visit bar, extensively 3) go back to chainsaw museum & demo saws of interest on the tree in...
-
If the tree gets cut down with a chainsaw...I wonder who they will look at first??
-
So far it hasn't happened. There is a bar right next to my buildings, they seem to get around it O.K. Mark
