Recent content by Scott chandler

Looking for opinions / comments here - i bought a new 572 10 months ago and 14 months left on warranty. Been really hard to find dealer close that has software for electronic carb but found one. Saw has been run very little since i purchased from member last April. Saw ran great until last...

I have an almost new 572 that’s doing it and i bet it has 3-4 hours on it. How long does husky warranty last ? Have a 562 that has never had a problem.

Rex i saw the -1 up there on the news / weather. Heck this mess here makes me want to move to fla for the winter no worse than it is. And to think i thought about some land out in Wyoming !!

That sure seems like a lot but it sure is warm air coming out of the vents. It’s not as hot as the air coming from the thermopride oil furnace BUT it sure is a lot cheaper . Of course my dad says - boy you coulda bought a lot of oil for 10 big ones - heck I’m not even sure how much fuel oil...

Well i wrote check for 15330.00 but that was for everything. Heat thing for my hot water Heat exchanger pipe fittings pump and all the valves. Now I’m supposed to get 26% of that back on my taxes so after a little ciphering i think out of pocket it will be about 10,730.00 And i have to...

I swear - I’m not sure why i didn’t do this years ago !!

Those pics are shortly after i set it off trailer. If you’re planning on installing yourself then when they deliver you have to have a big enough tractor to unload it !! Ask me how i know . Had to call a neighbor with a 60 hp tractor to raise it high enough to drive trailer out from under...

The colder it gets the more i like it

I have to post this for the fellas like me that have wondered or thought about buying water stove instead of burning a wood insert in fireplace in the basement to heat their home - that’s what I’ve done for years until. Now as far as savings it’s hard to say because i have a huge thermopride...

Who does porting and do you just send cylinder to them and how expensive is it ?

Fellas if saw is stock then it should be 50mm cylinder ? And tell me where i can find year it was made and wanted to ask opinions on the 52mm pop up that hyway has. Not sure if that’s wise or no. I would like for saw to hold up but a little more power be nice. If the cylinder holds up as well...

That’s what i will do - i need info on how to clean up oem cylinder - i have that ball with fingers ( forgot the name) used for cleaning up cylinder and i have a regular hone. Suggestions welcomed and also where is best place to buy meteor piston rings and a good open muffler. Tell me about...

So i am seeing 50 and 52mm cylinders and pistons - if i get into it this weekend and i do need both is meteor the route and caber rings or oem ? And the 52 or 50. I got to ask - how many up to the 52 and is it wise ?

Just caught the upside down dawg - didn't even notice. I love this forum and I'm chainsaw poor but Hun says i could have worse hobbies. What's FFS ??

on the tlc - I've never been big on looks vs performance but i got a couple buddies i cut wood with. We all help out each other and none of us cut trees for a living but it's kind of like ugly girlfriends. They're great to be with but you don't want anybody to see you with them LOL. In...