redneckhillbilly's latest activity
-
I would probably have been more interested in downloading the app if there had been a McDonald's burger as a prize. -
550.00 plus shipping
-
redneckhillbilly reacted to Squareground3691's post in the thread HUSQVARNA HUSQVARNA THREAD with
Like.
592 Tri port -
For the tl/dr crowd: carburetors gum up when they sit, and he needs help assembling a case. I see nothing "x-torq" specific here.
-
Decent 365 only non oem parts are clutch cover and high top conversion I have the oem low top system haven’t taken a compression test...
-
What’s the shortlist of easiest older husky’s to work on. I am looking for my next project and have never used a Husqvarna or worked on...
-
redneckhillbilly reacted to Bill G's post in the thread Should the Chicago Bears move to Indiana. with Like.
Taxpayers should never fund a stadium with tax dollars.
-
This saw is a 2022 model and in pretty good shape. Starts runs and oils as it should. I ran it with a 32” bar and chain for about 20 min...
-
redneckhillbilly replied to the thread MCCULLOCH The official McCulloch thread.did you buy this?
-
Also replaced the hard line that runs along the crossmember, under the engine, from drivers side to passenger side. While loosening the...
-
Fly tying vise.
-
Found another HDA 87, probably needs a kit. 40 dollars shipped. Starting the "ole ladys laptop fund"🤣
-
Now just think, if you need something a little bigger, go with the 592xp, it's the same but bigger!! 🤣
-
Took some of my Missouri-built saws and made a dedicated wall. (Left to right) Top Row : Mono 1-16(77cc), Mono 60-20(77cc), Mono...
-
redneckhillbilly reacted to Funky sawman's post in the thread ring & pinion seal replacement crush sleeve question with Like.
Crush sleeve eliminator, thats all i use, a shim pack stacked to set pre load. This job of setting up rear ends is the one i hate most...