redneckhillbilly's latest activity
-
Same here, I have a pair of Danners in the closet with smooth soles, I don't want to throw them out, but can't afford to get them... -
redneckhillbilly reacted to Mastermind's post in the thread The official OPE daycare thread with
Like.
You must have a hell of a junk pile. -
redneckhillbilly reacted to Squareground3691's post in the thread MCCULLOCH The official McCulloch thread with Like.
Just picked up this clean little 70cc hotrod ,
-
redneckhillbilly reacted to Wilhelm's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I used a 3.2mm wheel in a pinch on a full sized full chisel 3/8" chain not wanting to swap over to the 4.8mm wheel. The chain did cut...
-
redneckhillbilly reacted to Squish9's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
Hey look, a person that understands why a wheel is shaped and how to use it! I'm ashamed to admit, I only learnt this last year
-
redneckhillbilly reacted to Duane(Pa)'s post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I’m pretty sure those would be 1/4 and 3/8 LP? Might work for 3/8, but not ideal…
-
redneckhillbilly reacted to Philbert's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
If you keep repositioning the wheel and cutter, you can get close to a standard profile on full sized 3/8 pirch chain. Otherwise...
-
I can't stop laughing... This whole thread is hilarious but this is the cherry on top!!! Well played!!!
-
dont let ryan fool you. heres a pic of him and his “posse” on a starbucks run i think
-
redneckhillbilly replied to the thread Chainsaw grinder questions, tips, tricks, and pics!!!!.anyone successfully sharpened a 3/8 chain with an 1/8 inch thick wheel? I noticed on the chart in the back of the manual its lists a few...
-
redneckhillbilly reacted to lehman live edge slab's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I just have the cheap Oregon knock off grinders for now, I go 60 on head tilt 30 on top plate angles with the vice tilt at 0. Big think...
-
redneckhillbilly replied to the thread Chainsaw grinder questions, tips, tricks, and pics!!!!.whats you go to angle settings for a standard work chain?
-
redneckhillbilly reacted to Mastermind's post in the thread Not so pros 4 new and without politics with Like.
This contraption worked very well.
-
redneckhillbilly reacted to Philbert's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
That’s the place to learn! Sharpening other folk’s chains for free! Philbert
-
redneckhillbilly replied to the thread Chainsaw grinder questions, tips, tricks, and pics!!!!.I'm just a firewood hack, I cut about 15 cords a year, I only own a total of about 15 chains for use between my 4 saws. I tuned in all...