president's latest activity
-
PWhich is only necessary on very few saws, in fact the only one that comes to mind is the 266SE and XP, as it just has the blind holes...
-
PI actually have 90% of the factory tools to do this with.....but I use the tools @Mattyo makes most often. They're just so simple.
-
PAnd some carburetors have numbered fixed mains that flow a certain percentage of fuel regardless of the adjustable jet settings. Some of...
-
PI was a problem child. Now I'm a problem adult.
-
PFirst go at porting is off the bench. Before it was turning 11k in 16 inch hardwood with the same 24" bar with full chisel .050 rakers...
-
Ppresident replied to the thread SELLING Stihl 440.beautiful old saw!
-
PMore,
-
Ppresident reacted to Squish9's post in the thread Chain Service Tools and Sharpening Station with
Like.
That is an incredible setup. Here's my much worse looking sharpening rig Features include, Poor quality Oregon knock off grinder Some... -
Ppresident reacted to lehman live edge slab's post in the thread 024/026 with an 028 Super top end? with Like.
Yeah and now that I look closer the 191t won’t work ring locators all wrong for sure. 034 standard piston is 46mm and so is the standard...
-
Ppresident reacted to S&S_Work_Saws's post in the thread 024/026 with an 028 Super top end? with Like.
I searched high and low and even googled. I found several conversations discussing the combination but never anyone ever attempting it...
-
PSurely you will find where it's been tried before if you search hard enough. I thought I saw an attempt that didn't work out. The 028...
-
PA properly ported 026 top end on an 024 Super chassis makes a very fine runner - It's unlikely you're going to make much more power with...
-
Ppresident reacted to stihl #1's post in the thread Chain Service Tools and Sharpening Station with Like.
I have used the 15 degree setting for the last 25 years and never had a complaint, even had more than one occasion where I was told the...
-
Ppresident reacted to stihl #1's post in the thread Chain Service Tools and Sharpening Station with Like.
cus_delexe, I have 2 BP1 saws, one is complete with the bar and the sharpen on the saw chain and runs, the other is rough. I am still in...
-
Ppresident reacted to Mastermind's post in the thread Simplified---Adding A High Speed Circuit To A WG Carb with Like.
Ok. Just the basics. I start with a 4mm x 25mm allen head screw to make my needle from. The paper in the picture has the dimensions...