president's latest activity
-
PI didn't mean to start a pizzen match by mentioning the 038 mag .It would stand to reason however you should be able to get a tad more...
-
PEarly 181s take the smaller 503 26 02-04 Seal on the flywheel side, this is the same seal that is used on the 61/272 chassis. The later...
-
PAlso lucky I have a relationship with the pressure treater a few miles away so the treated lumber came off the mill as well.
-
PWhat he said.
-
PI would get the .325 x .050 gauge setup so you can run the new 23RS Pro narrow kerf chain
-
Ppresident reacted to S&S_Work_Saws's post in the thread 90cc class saws which one is the current king of the class? with
Like.
I've always had excellent luck with dolmars. Very well built saws with a broad torque and power curve. The 9010 is just a great saw in... -
Ppresident reacted to Woodpecker's post in the thread 90cc class saws which one is the current king of the class? with Like.
661s turn up really well too! Pretty hard to go wrong with one from any of the known porters. I like my MMWS 661 a bunch. In addition to...
-
Ppresident reacted to pbillyi69's post in the thread Chunking saw... before it hits the ground with
Haha.
i used my 357xp as my daily climbing saw with a 20" and full comp square chain if i needed more than that i had an 044 or a 372xpw and a... -
Ppresident reacted to cuinrearview's post in the thread Chunking saw... before it hits the ground with Like.
Still on the first. BGD, timing, muffler. Popup piston.
-
PGot a family picture of the all of the Husqvarna's I have: Front to back: * 136 (dump find) * 440 (well used store loaner saw) * 55...
-
PA simple tank vent from Echo can be utilized successfully in leu of the grub screws with the addition of just a tad bit longer fuel line...
-
Pmanual says 13.5k and service manual says 14k
-
PI had to wind 3 bits of solder together to get a squish measurement With the old gasket the squish would have been over 0.050 Fitted...
-
PI actually did take a swipe at the heart on this one. Thick side = tension.
