MustangMike's latest activity
-
This discussion reminds me of when I attended my first Kohler technical school at age 15. We were having all kinds of trouble right then... -
if you but quality oil and good gas it will be just fine as long as you mix enough oil into the gas
-
I think so much of this discussion essentially boils down to: If it works for you and performs as needed then just run it.
-
He has a PM group chat thing on FHC
-
Absolutely the fuel has an effect. I make gasoline for a living. The recipe for the soup that we call gasoline changes by the hour...
-
Different oils combustion differently and require different tuning.
-
I've never measured to know, butnit doesn't appear to run on hotter to me. Tuning properly and strato charging really helps with Cats...
-
The EPA isnt going away unfortunately. Catylitic Converters aren't all that bad. I have a Redmax Kombi with one and it works fine...
-
Well you could definitely do worse than Saber. I have used several oils and done a mini evaluation of them and Saber is right there at...
-
MustangMike replied to the thread What oil is best? and what ratio?.I run Amsoil Saber at 40:1 in all my 2-cycle stuff. Most of my saws are ported, none are stock. It burns clean, lubricates well and so...
-
bwalker... when I was small child I remember the oil that we had for our Mercury outboard motors (my dad was a dealer) and it was...
-
All of the ashless oils stink because they use amine in their chemistry. The smell of rotting corpses is from mines so needless to say...
-
Here is the Castrol sds... One thing I was not anticipating during my evaluations was the variation in gasoline. I have bought from...
-
MustangMike reacted to pbillyi69's post in the thread Post up your ported cylinder Artwork with
Like.
he brought it by when he first got it. i remember that it is stronger than my br600. always good to have a back up -
They are using a WY platform Walbro. At 80 cc they are maxing out the pump capacity of the carburetor, so there’s not room for much loss...