Maintenance Chief's latest activity
-
Maintenance Chief reacted to ManiacalMark's post in the thread HELP! Scammer Alert!!!!!!!!!!!! @Cupholder with
Like.
Yes -
Maintenance Chief reacted to Stump Shot's post in the thread HELP! Scammer Alert!!!!!!!!!!!! @Cupholder with Like.
Was for me, he had the very same part I was looking for and also at a moderate price if I would just contact him at his E-mail. Thanks...
-
Maintenance Chief reacted to ManiacalMark's post in the thread HELP! Scammer Alert!!!!!!!!!!!! @Cupholder with Like.
I was pissed to get a scam message about an sdm-4
-
That was me. If the foggy sail repair does not work this usually does unless the coil is bad which is pretty rare only had it happen to...
-
Any chance that this is the photo in question? red/orange silicone on the ignition plate, after the repair...
-
For the curious... As received 2 bolt on cyliders Mark
-
Disston DA211. I've had this saw for over 5 years and I decided it was time to get it cleaned up so I can put it in the display...
-
About the only way I could think to do that is to take a new chain and profile a pink wheel to it for a grinder. Only other possible way...
-
Maintenance Chief reacted to woodfarmer's post in the thread Husqvarna 564xp (g) fuel inject with Like.
I want a heated handle one, with all the plastics dyed red and I’ll call it a Jonsered 2664!
-
Oh....where might I buy a new one?
-
Id call Cannon also; If I were a manufacture Id prefer a review were its stated "they stood behind their product & made it right" even...
-
Maintenance Chief reacted to SawAddictedFarmer's post in the thread Cannon bar tip failure with Like.
Personally I'd call Cannon directly and give them a chance to make this right. Telephones were invented for a reason.
-
We moved a few saws into the new display area today. We also moved these Orline powered non-saws; drill and generator. The Orline...
-
Maintenance Chief reacted to Squareground3691's post in the thread HUSQVARNA HUSQVARNA THREAD with Like.
-
Maintenance Chief reacted to Bill G's post in the thread HELP! 5 Windsor bars 1 Carlton 36in with Like.
1050's are good saws........