Maintenance Chief's latest activity
-
The contractor had some vinyl laminate flooring left over from another project and finished off the floor in the upstairs bathroom. I... -
Maintenance Chief replied to the thread What's on your bench?.Probably 1 of my favorite saws for work, both felling and firewood. A little woods porting really wakes these up! Too much and you get...
-
I got my 394 all set up with the 50” .404 bar from Mike Rupely and the 48” Alaskan mill from @singinwoodwackr. Reprofiled the chain for...
-
Both or neither. That looks like a one eyed pirate.
-
The 441 lives again :p It is heavier than I expected at 17.2#, PO I suppose I should replace that missing muffler hole cap, :p
-
I had a bargain piston kit on hand, I don't remember now where it came from. Back together and running again. Mark
-
I took the buggy on a ride with a real feel of -5. The roads are terrible and a good 15mph breeze is blowing everything off my roof onto...
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with
Like.
I have some other 82cc McCullochs with similar compression that run and cut pretty well so I don't think that is a major factor. The... -
Maintenance Chief reacted to NZsaws's post in the thread MCCULLOCH The official McCulloch thread with Like.
PM700 picked up for US$60, Apparently has sat for 15 years, but put new plug in and ran on 3rd pull. Bit of oxidation under paint but...
-
Maintenance Chief reacted to Bigmac's post in the thread MCCULLOCH The official McCulloch thread with Like.
The bp1 looks great!
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
I had some 82 cc cylinders sleeved a couple of years ago and put one saw (SP81) together to give them a try. Cold compression seemed to...
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Mark
-
-
Maintenance Chief reacted to TheDarkLordChinChin's post in the thread So what did you do today? with Like.
Finally got the whole chain sharpened. Filed out the gullets with a 7/32 round file and took three strokes off the rakers. Some...
-
Maintenance Chief reacted to jacktheripper's post in the thread So what did you do today? with Like.
Milled some weeping birch for my buddy. Beautiful piece with spalting, interesting grain patterns. Used the 394xp, which pulled the 50”...