Maintenance Chief's latest activity
-
Maintenance Chief reacted to Jake Dykstra's post in the thread Square Filing Guide: 3D Printed with
Like.
Might be helpful but when square filing one needs to file the cutter in the other direction so as to not leave a burr -
Maintenance Chief reacted to Wood Doctor's post in the thread What yer cheap saw favorites? with Like.
One of my good friends has a Husky 455. I serviced it once. He loves the saw and uses it all the time. Not cheap: new ones run $600 with...
-
After a couple of weeks with very little activity, some progress was achieved this week on Phase 2. The area in the back was prepped...
-
Maintenance Chief reacted to Squareground3691's post in the thread MCCULLOCH The official McCulloch thread with Like.
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
If the tapers were clean, dry, and fit well and the clutch nut properly torqued (book says 160-170 In/#) it should be O.K. Since you...
-
-
-
Maintenance Chief reacted to MustangMike's post in the thread Post up your ported cylinder Artwork with Like.
Al, I remember you did some incredible work on my Hybrid, and I used it yesterday to drop this large Sugar Maple stem. The 28" bar was...
-
Maintenance Chief reacted to Normzilla's post in the thread Everyday day man's tree work and cutting thread with Like.
Two days of Hazard trees removal. Tall tree falling and limb showers. Steep ground, Annapolis CA by coast.
-
Maintenance Chief reacted to Normzilla's post in the thread Everyday day man's tree work and cutting thread with Like.
Nice! Refreshing to see a fellow Humboldt man
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Mark
-
Well guess WTF is on the bench again. You guessed it. I ran the 288xp today and made some cuts, but shut it down when I began to hear...
-
Maintenance Chief replied to the thread Post Oak - What saws?.My daily driver is a newer GMC with some fixin's, but I have a $300.00 1989 xj 4x4 and a fairly decent 91 Dakota extended cab v8. Every...
-
Here is a thought that’s been bouncing around my head. Curious about peoples opinions on it here. What do y’all think about picking up...
-
Go for it, if it doesnt work out, youre out what, 400? For a 90cc saw... part of the fun of saws is modding them... i got my ms661 for...
