Maintenance Chief's latest activity
-
More -
Is dinner ready yet?
-
It was an hour or so with a vice and a bigass wrench tweaking, checking, tweaking, etc but not too bad. I cut ~1" off the tank mount...
-
The missing link for this guy showed up a few days ago and I got tired of kicking a box full of parts so I slapped it together last...
-
All together again. I did give it a prime and it fired right up, but with the condition of the fuel tank I don't think I will bother...
-
Framing work continued yesterday with the improvement in the weather. Mark
-
Framing work began yesterday. The city is also in the process of replacing the utility pole in the alley at the end of my...
-
Got a family picture of the all of the Husqvarna's I have: Front to back: * 136 (dump find) * 440 (well used store loaner saw) * 55...
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with
Like.
The serial numbers are only helpful, not definitive. You need to find an IPL with the prefix listed (10-, 11-, 12-, etc.) and from the... -
Maintenance Chief reacted to hacskaroly's post in the thread MCCULLOCH The official McCulloch thread with Like.
Yes, the Super 10-10 (both right hand start and left hand start) use the low filter (pn 66992).
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
I decided to attack this 12-25 today. I wasn't quite sure what I would find under the grime, turns out there is no paint hiding...
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
If you have a photo of the saw look carefully at the AF cover, the one on the left (MAC10-10 & 10-10A or 10-10 Automatic) uses the more...
-
Maintenance Chief reacted to hacskaroly's post in the thread MCCULLOCH The official McCulloch thread with Like.
If you look through the 10-10 IPLs you may be able to narrow down the change over. I tried to fit a low filter on my saw and I don't...
-
Maintenance Chief reacted to ErnieG's post in the thread MCCULLOCH The official McCulloch thread with Like.
I'll shot you a p.m ... Ernie
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
McCulloch PN is 87674. I have a few NOS as well as some 3D printed ones that I make (and sell) as well. The 3D printed ones are not...