Recent content by lovin-J-reds

Its gonna run hot since I don't have the top cover. I cant tune it with it on since I put a different carb on it I drilled the hole to .055 and have both jets out to about 2 ish turns on both. I haven't cut wood with it yet as it is I've only ran it once and don't have much time due to work...

I got the saw to run but it sounds like its running rich and lean at the same time. It revs sky high and doesn't want to idle but to get it to you have to tap the throttle and slowly bring it down from wide open to idle but it idles down really slow and then picks back up to a high idle. Not...

Its all I got thats the *s-word saw. It was a parts saw and got all my parts and got it to run. I also dont want to spend $500 for a bottle I would love to try a turbo on the saw but I can't find the right size, I'm thinking the GT0632SZ which is the smallest turbo Garrett makes but I think it to...

So to bring this thread back, I've got a 97 2050 turbo and I'm tryin to run nitro methane or pure methane. Ive got a stock saw and I know I need to drill the jet but do I need to drill the L and H jets? If I do how do I do the jets? Timming??? How do I advance the timming? The coil is in a fix...

I wanna make a saw you don't see every day and in the past I've put this saw through forced air induction with and air compressor and it didn't like it one bit. I would need to find a small turbo and try that. I've gotten a bit of info but not enough. Thats why I wanted to make this cuz it's...

If anyone is a member of this forum https://www.arboristsite.com/threads/rc-nitro-in-a-saw.359171/ can you give me some help with it and if your not can you do it here please. I heard about people running nitro through their saw for a punch and good smells but what do you need to do to the saw...

I runs but it idles super high

I got one, still need it?

Thanks guys, I don't think I will need parts. I had a junk 49 that i use as parts and stole the piston and it look fine. How would I delete the gasket? Im going to try and start it today. I use high temp silicone I use it on a lot of stuff probably to much but it doesn't hurt.

I looking for a 70E with a chain break. Anyone out there selling? PM me. Edward

I ported my 49SP and need a piston and ring. would a 52 fit in a 49? I know they are the same. Would I be better off to buy a 52 piston and rings or a 49 piston and ring. Base gasket? Do I need a base gasket? Could I put it together and tighten it a little extra and not worry about it? Would I...