lehman live edge slab's latest activity
-
lehman live edge slab replied to the thread Stihl MS261 or Wait For MS300.I’d take that reliability bet on a 260 vs 346 they’re both rock solid and yes a 346 kicks an 026/260’s but. I’d expect that though since... -
lehman live edge slab replied to the thread 2013 Ford expedition front right brakes wearing out fast..Me too, did them at my uncle’s garage right on site l. Problem was they had rust in the venting and even if they met minimum thickness...
-
lehman live edge slab replied to the thread Vintage Chainsaw Museum.If i didn’t bring the ts-08 concrete saw adapter when i bought you the old 08 i need to bring with next time i come down
-
Thanks to Chris Lehman Live Edge Slabber I was able to get a couple more saws finished up and ready for the display. The 040 was...
-
lehman live edge slab replied to the thread 2013 Ford expedition front right brakes wearing out fast..Not really worth the time anymore to rebuild my opinion just because usually have a scored bore ext just get new ones and replace and i...
-
lehman live edge slab reacted to Fords1791's post in the thread 2013 Ford expedition front right brakes wearing out fast. with
Like.
Make sure the pads and installed correctly, there is an inside and outside pad on that era Ford. The pad with bumps on it is the inside... -
lehman live edge slab reacted to SawAddictedFarmer's post in the thread 2013 Ford expedition front right brakes wearing out fast. with Like.
Warped rotors is my best guess
-
lehman live edge slab replied to the thread Gas blowers in Virginia under fire ...That’s fine unfortunately not many are willing to spend the money and or can afford to. Right now unless everyone switch to USA made...
-
lehman live edge slab replied to the thread STIHL The Official Stihl Chainsaws Thread.They definitely aren’t light
-
lehman live edge slab reacted to Stump Shot's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
@mirage saw was really enjoyable to work on, could have stood to have a saw bearer when it came time to run it though. Saw and bar...
-
lehman live edge slab replied to the thread Bigger setup for CS milling.Only problem is planing a 40-50” wide surface with a router and homemade sled is not a fast or easy task neither is sanding. The last...
-
lehman live edge slab replied to the thread Stihl MS261 or Wait For MS300.261 is definitely easier on hands also.
-
lehman live edge slab reacted to Stump Shot's post in the thread Stihl MS261 or Wait For MS300 with Like.
Second correct answer is, the MS261 can be quite the nasty little m'fer when ported with the bottleneck points addressed when doing so...
-
lehman live edge slab replied to the thread Bigger setup for CS milling.I’ve used both in .404 and 3/8”.
-
lehman live edge slab reacted to Stump Shot's post in the thread Stihl MS261 or Wait For MS300 with Like.
I believe, the correct answer is to buy a MS261 now and a MS300 later. If still unsure about it buy a 550xp as well and have a good time...