Ketchup's latest activity
-
My caliper was hanging up and TSX brakes fit with a little cutting and bending. Got junkyard calipers and new pads and rotors. I’m about... -
Got my new work bench installed today no more using the Jeep tailgate lol. This was part of the countertop when my dad first built his...
-
For 340/345 conversion. I was planning on one, but got a couple of bases in the mail today....
-
Jonsereds 111S’s if anyone is interested. FB marketplace Two Rivers, WI
-
-
Ketchup replied to the thread So what did you do today?.You’re right about that. Hard to soft catch a 1000lb lathe. The only damage is where I had to jack on the pan to get it back up...
-
Ketchup reacted to SOS Ridgerider's post in the thread Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread with
Like.
Here you go David. Some slight differences. -
-
Bling - Thanks to AWise_mac_nut for bringing this to my attention. I had a piece of round ground chisel chain with the McCulloch...
-
-
Some progress the past couple of weeks in spite of the hot weather and occasional thunderstorms. Some walls going up inside...
-
Ketchup replied to the thread So what did you buy today.The lathe runs a 5hp dual stage motor. My understanding is I need a rotary converter with at least a 7.5hp motor but 10 or higher would...
-
Ketchup reacted to SOS Ridgerider's post in the thread Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread with Like.
This thread needs a bump. Been months since the last post, and these saws are too good, and too much fun, to let this thread die. Here’s...
-
Ketchup reacted to MustangMike's post in the thread What are you building with your milled wood? with Like.
Nice! My upstate cabin is 20 X 24, but 2 stories high. It replaced the 12 X 20 one story high that just never seemed big enough if you...
-
Philbert
