Recent content by Jazzlesaurus

Same thing happened to me, look out for email addresses typed out, or copy and pasting exactly what you're asking for word for word. email at email dot com rather than email@email.com I had someone message me with "Oregon RWD bar ideally for 395xp" which is the exactly phrase I used in a WTB ad...

Compared to the stock muffler, or a basic muffler mod if you've tried it, how much louder is it? Most of the DIY or porter modified mufflers are thin steel, this looks like relatively thick aluminum. Wondering if that's impacting operator experience significantly.

Pretty sure this gets posted every couple months, but I'm looking for a reduced weight Oregon bar. Ideally a 32" D009 .050 for my 395XP or 24" for my 372XPG, but would also be able to put a 28" to use. These bars look cool, performance and other better bars aside I want one for fun. Thanks!

I can't seem to sell my XPW. You won't regret it - a key part of my Cool OE Trifecta.

PM sent.

Some oils are meant for higher heat applications like the 800 and certain additives seem to turn to carbon deposits. Lots of great oils. 710 as suggested, Amsoil Dominator, Honda HP2, Klotz Techniplate, not sure what’s available to you.

Looks good, run 40:1, ideally grab a better oil. The XP seems to protect well, but when I tried it, I ended up with carbon everywhere. I ran about 4 gallons through my 562XPG and the whole top was carbony, even under the rings. Switched that saw over to Red Armor and after half a tank it was...

These Total bars look so good on Jreds.

Huge fan of heated grips. You won’t regret it.

Is this every 8 teeth? For those who want to run a 36" bar on their MS170...

If only they still made 346's like they make 10/22's...

I saw a post they made replying to a similar Facebook thread where they explained they are a family business of only a few folks and they had a death in the family and are swamped as they were growing rapidly. No affiliation with them or have even placed an order with them, but that would...

C83 has cut 2.3 cords. Sharpened twice. 2 strokes on each raker..... Bill G needs to fill out his signature.

If a saw is going to come around and get me good, I kind of just want it to make a clean cut and keep going anyway.

I knew one friend was looking for a 2101XP, and another was looking for a 390XP. I found this seller who had both. Turns out, he also had the 372XPG posted. I was able to scoot up from Western MA and grab all three saws and some sweet sweet ethanol free pump with the buyer of the 2101XP. The...