jacktheripper's latest activity
-
jacktheripper reacted to lehman live edge slab's post in the thread Post up your ported cylinder Artwork with
Like.
Ground the holes bigger 😂 -
jacktheripper reacted to lehman live edge slab's post in the thread Not so pros 4 new and without politics or drama with Like.
Both to tough to choose so need to alternate the starting rolls
-
jacktheripper reacted to ammoaddict's post in the thread Not so pros 4 new and without politics or drama with Like.
288, because it's a Husqvarna.
-
jacktheripper replied to the thread Not so pros 4 new and without politics or drama.Which one would you pick up first, and why?
-
-
Mark, When I asked this........ ....it was a serious question.
-
So instead of trying to reused the steel line I made some fittings and used some good rubber tubing. I found the bar clamp but...
-
@jacktheripper has a 288 for sale
-
I have used the cj7 tailgate for a long time until recently getting my bench in place
-
Wait till you see the F-150 tailgate!
-
jacktheripper reacted to Tor R's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning folks
-
-
jacktheripper replied to the thread Not so pros 4 new and without politics or drama.About to go do some big stuff
-
-
Early models had both an inside and outside steel bar pad, later models had just the inner one.
-
jacktheripper replied to the thread SELLING Fully Rebuilt 288xp.I should also add that in the picture, it shows a hiway gasket set. I used OEM gaskets for the carb and manifold I believe. Just used...
-
Those are excellent bearings. Used exclusively by heavy equipment OEM's.
