huskihl's latest activity
-
huskihl replied to the thread treemonkey stuff.Stratos open earlier than stock after lathe work, just like the intake. They usually open about the same time, as that’s how it works... -
Well his job went South so we rescheduled for Friday. Instead we butchered the huge 8 point buck we found at the end of our driveway...
-
-
Among 110,000+ friends yesterday.
-
Got my limit again on Friday. Lots of fun and we like to eat em, too!
-
huskihl replied to the thread The Great 2-stroke debate : Compression vs Flow.No set rules. Compression adds torque, but it’s also hard on the crank. Many saw porting guys base their reputation on unloaded speed...
-
huskihl replied to the thread HELP! How to know when you have too much hook.It works better than leaving them horizontal. Ideally they would be rounded or have about a 6–8° down angle
-
The point about not making the exhaust port port walls mirror smooth is an interesting one. A rough surface reduces laminar flow at that...
-
huskihl reacted to Fleethirte's post in the thread HELP! Chinese clone chainsaws - worth the hassle ? with
Like.
worth the hassle only as a hobby. Its fun to get the parts kit and put a saw together 1 pcs a time and then see if it runs. My first... -
huskihl replied to the thread HELP! Chinese clone chainsaws - worth the hassle ?.Like others have said, you need to be able to tinker to keep them working properly. Most that have bought them say that by the time they...
-
huskihl reacted to HumBurner's post in the thread HELP! How to know when you have too much hook with Like.
Thats about where I like my chains for bucking hardwood; looks durable with a lot of meat. Also looks like you're getting a bigger bite...
-
You were right, gentlemen. The freeporting wasn't causing the problem, the AM carburetor was. Metering lever was at the right height...
-
huskihl replied to the thread How many degrees timing advance MS 400?.They are also cooled by fuel when it hits the piston. Heat can be a good thing as long as there’s ample fuel and air to get the job...
-
huskihl reacted to tree monkey's post in the thread How many degrees timing advance MS 400? with Like.
i like 10deg
-
Try the thinner gasket again and add a husky 395 blue button decomp to it. See if you can start it. The Husky decomp is a direct bolt...