huskihl's latest activity
-
Zip tie that throttle wide open (very dangerous) unless you can man handle it and yank while holding trigger. Probably smoke show until... -
Some pulls with fast idle engaged might get you going. If not, set the bar tip on some wood, hold the throttle wfo with your right...
-
I'm wondering if I just misdiagnosed what was happening. Is it possible the fuel was restricted enough to prevent starting, but not...
-
I find that if you run the saw empty, refuel and then restart, if the saw is still hot/warm then using the choke will result in the saw...
-
I left the choke lever out on my first attempt, after refueling. I figured the saw was starved for fuel because I continued pulling with...
-
If the burr is more than what you can scrape away with your fingernail, then the cutting surface is overheating. If you have access to...
-
huskihl replied to the thread I am slightly confused.Glad you like your saw. Did you accidentally leave the choke lever out? If not, the only other way fuel gets through the system is...
-
huskihl reacted to srcarr52's post in the thread HELP! Help with first time porting Echo 800P with
Like.
My right angle handpiece will work with the Dremel Fortiflex motor as it's a key drive cable just like the Foredom and all the imports... -
I did a few resets when I first learned it could be done. Haven’t done one in years. Seems like the saws don’t GAF how much I fondle...
-
huskihl replied to the thread M Tronic Reset.Yep. It’s the brain of the whole system.
-
That makes a lot of sense, as the coil has control over the carburetor to make changes, not the other way around.
-
huskihl replied to the thread UPCOMING NMI fall gtg.
-
-
🔥
-
my thought also,, i have changed the solenoid on the one and no change,,
-
huskihl replied to the thread M Tronic Reset.For what it’s worth, I always replace the fuel solenoid and filter first on one with running problems. Had a 201t that was idling high...
