huskihl's latest activity
-
huskihl replied to the thread STIHL 2016- 362 C.I just ported and installed a newer style slanted cylinder on an older straight fin saw and everything went together and ran perfectly -
I know it’s an old thread, but, turkeys are where it’s at!! Pictures are Pennsylvania, Kentucky, Montana, Hawaii, and Missouri...
-
huskihl replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.I’ve only seen 4 of them. Not familiar enough with the fuel line routing
-
huskihl replied to the thread MS400.1 c-m.I don’t believe there’s any “low emissions technology“ in a 500. They burn almost as much fuel as a 661. Spark plugs are always...
-
It’s a what you perceive as the best in your mind I guess, like it or not the mtronic/autotune has saved a lot of saws that would have...
-
Is there a cure for this , I have 4 of my 044`s out on permanent loan. I made no deals for them to be held captive , mostly it was a...
-
Hi Bill, Didn't see a service manual. Attached is a parts manual. Link shows a SD section with operator's manual and general service...
-
huskihl replied to the thread SOLD Simington 451C.Oops. 60-80% higher 🤦🏽♂️😂
-
huskihl replied to the thread SOLD Simington 451C.Yep it is. I believe it’s more recent than that even. I think Silvey had been shut down for quite a few years when I bought mine in 2016...
-
huskihl replied to the thread Clutch covers too narrow for good chip clearance.I saw “woodshop” in your name and figured that’s what you’re doing. If I were making 4 foot long boards, that’s the way I would cut it...
-
huskihl reacted to mac's woodshop's post in the thread Clutch covers too narrow for good chip clearance with
Like.
Thanks for much information to all the posts. Some things I did not know for sure. Appreciate you all !!! I have a 48 inch bar on the... -
huskihl reacted to Lions fan's post in the thread Kawasaki engines...are they really that good...not seeing it with Like.
Mine is an aftermarket Bercomac, built in Quebec. I have replaced the electric hoist, a bunch of shear pins and a couple belts over the...
-
Stihl 18" Rollomatic® E Chainsaw Guide Bar - .325" Pitch (.050"Gauge)...
-
huskihl reacted to Kiwioilboiler's post in the thread Kawasaki engines...are they really that good...not seeing it with Like.
Oohhh, oil thread ?
-
huskihl replied to the thread 084 Carb Diaphragm Help.The forked lever works fine with the non-forked diaphragm. I believe the lever goes flush with the lower floor as well