hacskaroly's latest activity
-
I carry a shoelace in my saw toolbox to tie down the trigger at WOT, easy and fast enough to take it of once the engine starts to... -
Not sure how this compares with other vendors, but I’ve been selling these for a while - my current pricing below. Chisel files -...
-
I know the price of Pferd double bevel files are ridiculous.
-
hacskaroly reacted to Rallyeguy's post in the thread MCCULLOCH The official McCulloch thread with
Like.
These are all over ebay and lots of guys have them as the cranks didn't go bad on these saws. Best thing is to find a used one with... -
Some pulls with fast idle engaged might get you going. If not, set the bar tip on some wood, hold the throttle wfo with your right...
-
Zip tie that throttle wide open (very dangerous) unless you can man handle it and yank while holding trigger. Probably smoke show until...
-
The/my PS-6400/7300/7310/7900 are notorious for doing this. Once they pull fumes into the carb they won't start due to fuel starvation...
-
hacskaroly reacted to Excaliburrr's post in the thread HELP! Stumped on Stihl TS420 rewind starter with Like.
Hello, I am trying to repair my friend's TS 420 cut-off saw, specificially the rewind starter. The issue is this: The pawl will not...
-
I'm wondering if I just misdiagnosed what was happening. Is it possible the fuel was restricted enough to prevent starting, but not...
-
I left the choke lever out on my first attempt, after refueling. I figured the saw was starved for fuel because I continued pulling with...
-
hacskaroly replied to the thread I am slightly confused.I find that if you run the saw empty, refuel and then restart, if the saw is still hot/warm then using the choke will result in the saw...
-
hacskaroly reacted to edju1958's post in the thread MCCULLOCH The official McCulloch thread with Like.
I didn't find the short block for the 10-10 today,but I have a couple other places to look.The crank on feebay (according to the seller)...
-
HVAC were on site today preparing for the mini splits. Electricians were at work as well, here they are putting up lights in the...
-
Glad you like your saw. Did you accidentally leave the choke lever out? If not, the only other way fuel gets through the system is...
-
XS372xp, recently acquired, great saw. 5 tanks through, runs and cuts great. I'm cleaning up a dead fall, working until dark. Put...
