hacskaroly's latest activity
-
Thank you for checking -
Hello, Would like to request a service manual for: PB-5810T PB-9010T SRM-3020 Thank you.
-
For those vineyards and wineries that make it, they make it BIG. I make my own wine now, and it is quite simple. Yet it is all about...
-
hacskaroly reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with
Like.
Scott, I would normally start with 1-1/14 turns open on both H &L. The fact that it starts with throttle and no choke would indicate... -
hacskaroly reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Ed - your PM55 has points ignition, make sure any crankshaft you get has the points cam/lobe. All of the 54, 57, 60, and 71cc 10 Series...
-
hacskaroly reacted to edju1958's post in the thread MCCULLOCH The official McCulloch thread with Like.
Mark,according to the IPLs I have,the PM10-10 & the PM55 take the same crankshaft,part # 87699 for both.I've got a 10-10 short block...
-
Has anyone here given any thought to the idea of opening an independent saw shop? Basically, a non-dealer shop that fixes saws and sells...
-
hacskaroly replied to the thread Great Wine.I took a tour of the Samuel Adams brewery in Massachusetts with a few of my coworkers. I don't drink, but figured I would drive for...
-
speaking of nails...
-
Glad you're on the mend!
-
Awesome information!
-
I'm guessing it should be at operating temperature prior to any long duration throttle pinning? So, if a reset isn't performed, will the...
-
I was, too. It was many years ago though. My grandson works at an Ace Hardware, they want to send him to Va. Beach to school. I would...
-
Also, if saw is 2.0 it usually wont have any markings from memory, but on the emmissions lable there will be an M3.0 if its 3.0, see on...
-
If mtronic 2.0 its leave in choke for 90 sec and shut down, if 3.0 its choke for 30 sec then pin full throttle, it will rev limit at 3/4...
