hacskaroly's latest activity
-
I get it. It's just lately, internet discussions feel dominated by trolling. If you want to make jokes, post memes, fine by me... -
-
hacskaroly reacted to legdelimber's post in the thread Trimmer Lines Breaking Off Inside Speed Feed with
Like.
Wish I had something helpful about the aggressive line shapes and welding on the spool. The water idea was my best shot. I've tried a... -
hacskaroly reacted to ray benson's post in the thread Trimmer Lines Breaking Off Inside Speed Feed with Like.
Soak the trimmer line and check the metal eyelets where the line comes out of the head - don't want sharp edges.
-
hacskaroly reacted to Bluzharp's post in the thread Trimmer Lines Breaking Off Inside Speed Feed with Like.
Changing back to round cross section line has just about stopped the internal snapping problem for me. My current roll is Husqvarna...
-
As a suggestion for repairs of torn boots Loctite 401,which is o-ring glue is the hot ticket .O-rings are made of buna n rubber same as...
-
A little bit of grease will keep it from pinching.
-
The cylinder might clean up using a few drops of muriatic acid on a qtip to remove the bulk of the aluminum transfer. And then try some...
-
When I was a kid I thought the wild thing was the coolest saw ever. I think the older poulans are great saws. The new strato poulan saws...
-
The CV models were very fine saws. I have a 5400 that I still use from time to time, and another in the display in my small chainsaw...
-
Keep an eye out for a bigger Mac for me so i can get it the next trip down.
-
The city of Dike has their "Watermelon Days" this weekend, I am planning on getting a few saws ready for Baraboo and putting them on my...
-
I would personally wait. If it isn't leaking I say leave it alone. In my opinion sometime messing with them creates a leak when...
-
Gotta pay for them fancy shops full of snapon tools somehow. Yeah ridiculous what it cost these days to get shop work done. Wanna see...
-
Do the other one now, or do the other one later. You have it figured out now and can probably do it in an hour this time. And yes...
