ferris's latest activity
-
Your mileage will decrease in the winter, but ita not the fuel itself. Its the fact that during cold weather to maintain the correct... -
Big, dead, ivy covered ash. Noticing a pattern? Right along a road outside a small town. Power line too. View from the field...
-
Top Tier cares about the detergency, which allows a range of compositions that meet the proper overall burning characteristics. Top...
-
I’ll soak up whatever build threads @drf256 can muster. I’ve read them all several times over.
-
I wouldn't pinch the groove closed too tightly and then re-grind the because you'll weaken the rails at the top. We used to close the...
-
I put a straight edge against the side of the bar and a cutter, the cutter tipped sideways enough that it did not hold the straight edge...
-
461 cranked up, coming off the tip. 30” was ok previous day. Some trees were quite wet. I checked my cottonwood vid with 288 and...
-
ferris replied to the thread 400 CM Build.Thx for a Build thread :)
-
I stand corrected. I only see a Stihl brand marking cast on the jug. It does have the typical Mahle patina though. Mahle are much...
-
They all look like this. I bet it’s oxidation after the casting. Good eye. This saw is 100% brand new. This patina probably explains...
-
I’m pretty darn SLOW. Got the band cut and nothing else. Next weekend, the base.
-
This won’t be a speed build by any means, so I hope you’re all patient.
-
Seems like we need a build thread here. It’s been too long and traffic has slowed, I hope it gets busier. I’d doing a good friends...
-
The fact that this thread has accumulated over 1000 pages without completely devolving into grunts and pointing is impressive.
-
@lilspenny look up eggshooterist
