edisto's latest activity
-
The fuel pump in the carburetor does not have a flow perfectly correspondent to fuel requirement. If it did, then theoretically you... -
Little bit of clarification here. The impulse signal created when the piston goes up and down moves the flaps on the fuel pump diaphragm...
-
I have a visit from a certain Mr. McCulloch today. I (now) know who this Mr, McCulloch is, as well as Mike, Alex, and Brent, but Don...
-
As the drywall work goes on inside, the carpenter is working on getting the outside finished. This week he's working on windows in the...
-
i got this a week ago for a decent price on fleabay with the original sheath and a kydex one too.
-
Miguron perism
-
Those USA Old Timers were excellent low cost knives.
-
Barlow 2 blade 70s, old timer stockman middleman (grandpa's - rip) '80s, Leatherman sidekick 20s, unlabeled scout '60s-70s, old timer...
-
Nice it theory but spending years in jail over 2-3000$ in stuff probably not the most fun.
-
The GTA-26's bar is too short to compare to these... You can put the Milwaukee 8" bar on a MS 170, no modifications needed...turns it...
-
Todd just tested battery-powered pruning saws. The Milwaukee had a pretty impressive showing:
-
done just that many times
-
edisto replied to the thread HELP! Understanding piston design.It also can be a good way of dialing in timing with a cheap aftermarket piston before cutting on an expensive jug.
-
Reminds me of a movie quote. Lol
-
I always put a very thin layer of motoseal on both sides of crankcase gaskets. I’m sure it’s not necessary but I figure that everything...
