edisto's latest activity
-
Yet another Frontier/Skill/rebranded saw for the display. This one says Husqvarna... Mark -
edisto replied to the thread So what did you buy today.
-
-
edisto replied to the thread So what did you do today?.Yesterday's milling haul (the unsticked pine on top of the oak slabs):
-
-
Cut old stinky out from under the kitchen sink cabinet…
-
Working on getting my new firewood seasoning rack done.
-
Good call and I apologize. @two4spooky Thank you for your perspective and also your support of our business.
-
Don't forget pictures 👍
-
just saw this. Did you get it running? Should run with a little tune. I had it idling nicely.
-
edisto replied to the thread So what did you do today?.I haven't messed with it yet apart from getting it set up, sharpening the chain, and getting it to pop off with a little fuel. I still...
-
Good old ireland 🤣🇮🇪🇮🇪
-
Red Beard V -Stack ,👍
-
I've been down this rabbit hole, without any apparent rhyme or reason some tensioner bolts have e clip notches, others don't. I recall...
-
I pulled the saw out this weekend and took out the carb, I was right, I had smashed the gasket between the carb and intake gasket and...
-
Get a cheap 8mm or 5/16 deep 1/4 drive socket. Chuck the socket up in a drill and turn it down on a bench grinder. Just go slow with...
-
edisto reacted to hacskaroly's post in the thread Stihl FS80AV (4112 Series) Carburetor Rebuild with
Like.
Most carb kits you get will not have an extra spring in it, so be really careful when you replace the main needle that the spring does...
