Recent content by Callum

i was looking for a way to use my current carb.

I have recently purchases an 084 fitted with a tillotson HT-2 Carb. the carb seems to be over fuelling the saw even at its leanest setting. I believe these carbs have a second high speed circuit. My question is, has anyone else come across this issue before, and if so what was the solution? I...

hi Ray. i was wondering if i could get a copy of the stihl 084 workshop manual?

I run the genuine Husqvarna oiled foam filter, it does a much better job of blocking out the fine stuff.

I find that having the rakers of the chain right is the biggest influencer on chatter, make sure you keep a bit of forward slop so they don't dig in, run them so each tooth takes an even bite, and have a little bit less bite. i also file my chain at closer to a 25* angle than a 30* angle. but...

Hi all, though i would share my 3120 build. i have pulled it apart and started to put it back together after a bit of a slap dash build. i am building the saw for reliability and as such it is remaining pretty stock. there are a few things i am doing that i didn't do on my first build such as...

Just some guy from the land down under, where upside down bars are the right way up.

awesome build. just picked myself up a nice running short case 066 for a slab of jack. I think it might be the first saw I leave alone for a bit, just a clean up and a few new rubber parts.

Hi ray I would really appreciate if you,could shoot me those manuals too

i have been lurking for a while and was hoping my channel might help someone new like i was

hi all. i am looking for a stihl 044 crankcase. preferably an earlier model. i only need the clutch side but would prefer a whole set. i am in Australia. cheers

hi, i would love it if you guys could check out my channel. https://www.youtube.com/channel/UCdwVCdCHF-ABdETOmeKUlYg?view_as=subscriber