Bjorn's latest activity
-
Bjorn reacted to Motorka's post in the thread Any Chinese chainsaw and chinese parts discussion with
Like.
Try , report. -
I’m not sure which one I have but it’s been solid. Will buy more in the future.
-
Plug holes only strip from over tightening or from plug not being tight enough and rattling around till the threads are chewed up. There...
-
Bjorn replied to the thread Chain changing tension as it rotates.Not really. But like many other stuff, a break in period. I have had same problem like this, I just run one tank of fuel. When cutting...
-
Bringing this one back up after a few years of slumber….picked this up today…
-
Bjorn replied to the thread Chain changing tension as it rotates.I wouldent worry so mutch. Just run it for a day, then check if it still slacking. Usually the problem Will disapere.
-
Bent crankshaft…
-
I agree, but competence is so lacking in today’s world that I’ve become somewhat cynical.
-
You can raise the transfers if you pull off the transfer caps. That will increase your torque band.
-
Yes, we installed a water mister/air kit that prevents tooth burn. Burning the tooth was definitely an issue before doing that if you...
-
I’m telling you marvel mystery oil and slick 50 as a 50/50 mix at 16:1 is good stuff😂
-
Hi D:couch: https://opeforum.com/threads/346-stuffers.16980/
-
Bjorn replied to the thread The 2025 346xp Porting Thread.The stuffer on flywheel side fits whitout modification. Clutch side a little grinding and a washer. Also some jb welld to hold it in place.
-
Bjorn replied to the thread The 2025 346xp Porting Thread.
-
-
Bjorn replied to the thread The 2025 346xp Porting Thread.
-
