Basher's latest activity
-
I downloaded an adblocker app. Or you can also pay a small gold member fee and get rid of them. It costs money to run the forum and... -
Basher reacted to Mastermind's post in the thread Simplified---Adding A High Speed Circuit To A WG Carb with
Like.
That's the simplest I can explain it. Questions? -
Bringing this one back up after a few years of slumber….picked this up today…
-
if that’s the case .005 is pretty excessive. Usually the grooves are about .001– .002“ wider than what the ring is just for oil clearance
-
It seems a bit weird that it’s in a generic Oregon box, although it’s entirely possible that “Chainsawbars” simply assembled the loop...
-
Line clearance. Insulated low voltage lines this week. We call them "bundle" because theyre usually a few lines plaited together. At...
-
In my new system, parts saws are in the parts department so I only count runners. A runner is defined as fully assembled, including bar...
-
Bump
-
1118-400-1001 should work. you might have to adjust timing. new from stihl $38.00
-
Basher replied to the thread New member.It gets worse when one loses count as I have saws I have not seen in 20 years now, then there are the saws I have never unpacked from...
-
Welcome to the forum where everybody is an expert!
-
Here’s where the identification tag is if that helps.
-
A few weeks ago. Yesterday. May be the oldest Husqvarna I have in the display for now. Mark
-
Can you take it all apart and weight the fasteners piece by piece for me ? And also with every bar and chain combination you could...
-
I have only used the "regular" stuff as hacskaroly has shown above. If you need to press some screen wire into it for reinforcement, I...