What's on your bench?

[MustangMike]

If the rings are free, that scratch on the piston may not hurt much. I'd be more worried if it were on the intake side.

 

[SOS Ridgerider]

If the rings are free, that scratch on the piston may not hurt much. I'd be more worried if it were on the intake side.

Ring is free, and nothing on the intake side, but I’ll replace the piston just for good measure. It’ll make me feel better knowing it’s done. Lol

 

[166]

Ring is free, and nothing on the intake side, but I’ll replace the piston just for good measure. It’ll make me feel better knowing it’s done. Lol

Just run some straight gas and a cap full of that stuff in there.

 

[RI Chevy]

LMAO. I now include that in my mix. I figure it can't hurt, right?

 

[SOS Ridgerider]

Just run some straight gas and a cap full of that stuff in there.

I think I’ll run a half cap full now

 

[MustangMike]

I had an 066 with similar piston damage. It ran just fine, but it bothered me, so I swapped out the P+C for the Cross P+C. It is the one on the HL Supply website.

I have since acquired another OEM 066 jug so I plan to put the Cross P+C on an AM frame and make the original 066 all OEM again (with a Meteor piston). Will give me an opportunity to practice my port work on both jugs.

 

[MustangMike]

What am I missing???

 

[RI Chevy]

I guess it will be a MMWS.
Mustang Mike Work Saw. [emoji16]

 

[RI Chevy]

What am I missing???

Fuel conditioner. Steve had a small Dolmar that runs straight gas with a cap full of this fuel conditioner. Insides of saw look perfect. I ran 2 full tanks at Sondres house a month or so back. You gotta see this to believe it.

 

[MustangMike]

Hey, no stealing Randy's stuff, that is why my stickers say "Mustang Mike Enhanced", but I also have saws with Randy's sticker!

 

[RI Chevy]

LOL. Too funny. [emoji1787]

 

[166]

 

[cuinrearview]

357xp muff

 

[RI Chevy]

Did you use solder? Nice square hole

 

[cuinrearview]

Did you use solder? Nice square hole

Thanks. If I make everything clean and easy my friend will TIG it for me. Makes for a clean finished product.

 

[RI Chevy]

Nice...[emoji106]

 

[WillG]

A chilly morning of testing boats at work...

Sent from my E6910 using Tapatalk

 

[Canadian farm boy]

HT75 pole saw getting a new carb thanks to ethanol and a KM90R Kombi unit getting a carb rebuild. Found a couple loose screws and the old carb gaskets just ain’t sealing things up good enough anymore.

 

[merc_man]

Cute little tiny welder is on my bench

Sent from my SM-G950W using Tapatalk

 

[WillG]

Old backpack blower runs strong!!

Sent from my E6910 using Tapatalk