SOLD MS 660

[Cracker Boy]

New fuel line new fuel filter,New caber rings, timing advance, rebuilt carb, I gutted birdcage out of muffler and dual ported it. And brazed deflector on flywheel side. New bar oil plate, I think I put new seals in it as well but can't remember. Saw is clean and a strong runnet. No less then 750 shipped to lower 48. I'm listing this saw for a friend I have gone thru saw he wants to fund an 880 for milling is only reason he's selling

 

[Cracker Boy]

 

[blacksmith]

Good looking saw!

 

[Cracker Boy]

Bump

 

[Coltont]

Bump

What clutch cover is that?

 

[Cracker Boy]

What clutch cover is that?

After looking and doing some research it's off a 661. I did the work on saw. I never paid that much attention to it. I listed it for a friend who wants to sell it because he's wanting a bigger saw for milling. It will have the correct cover when sold. Also he has felling dogs he took them off to mill. Good eye on cover

 

[Cracker Boy]

Someone broke into his trailwr over weekend stold this 660 a 026 a 036 and 036 pro I had built and sold him the only saw they didn't get was the 064 I built cuz it was in hi truck

 

[Gary Courtney]

Someone broke into his trailwr over weekend stold this 660 a 026 a 036 and 036 pro I had built and sold him the only saw they didn't get was the 064 I built cuz it was in hi truck

Sad !

 

[Dub11]

Someone broke into his trailwr over weekend stold this 660 a 026 a 036 and 036 pro I had built and sold him the only saw they didn't get was the 064 I built cuz it was in hi truck

Damn that *f-wording sucks.