G
Greenerpastures
Guest
Hello again everyone.
I need your opinions regarding
the correct mix and carb adjustment on a Makita 6100
This saw is Stratafied, it has a reed vavle,
this concerns me in regard to keeping it as
clean as possible, and the only way to do this is to use
the correct mix ratio and tune it to run right.
So what mix would you all reccommend, 40:1 or 50:1,
50:1 is specified, its a new saw, and I want to ensure it
gets enough lube.
Carburettor,
Does anyone know if the carb on this saw has restrictors
fitted, to one or both needles.
If so, then has anyone any advise on removing them.
Or do these saws normally come with enough headroom
in the restrictor to allow safe adjustment, to keep her rich enough.
Carburettor adjustment,
This saw according to the spec sheet runs 13,800 max rpm with bar and chain on.
Would I be better to use a tachometer, and adjust the H to between 13,200 and 13,300
for the run in period.
Are my mumbers ok or would you all reccomed a lower rpm setting,
keeping in mind am trying to keep her clean so as not to clog
the reed with uny neccessary oily residue.
I look forward to your opinions, and thank you for them.
Kind Regards, john
I need your opinions regarding
the correct mix and carb adjustment on a Makita 6100
This saw is Stratafied, it has a reed vavle,
this concerns me in regard to keeping it as
clean as possible, and the only way to do this is to use
the correct mix ratio and tune it to run right.
So what mix would you all reccommend, 40:1 or 50:1,
50:1 is specified, its a new saw, and I want to ensure it
gets enough lube.
Carburettor,
Does anyone know if the carb on this saw has restrictors
fitted, to one or both needles.
If so, then has anyone any advise on removing them.
Or do these saws normally come with enough headroom
in the restrictor to allow safe adjustment, to keep her rich enough.
Carburettor adjustment,
This saw according to the spec sheet runs 13,800 max rpm with bar and chain on.
Would I be better to use a tachometer, and adjust the H to between 13,200 and 13,300
for the run in period.
Are my mumbers ok or would you all reccomed a lower rpm setting,
keeping in mind am trying to keep her clean so as not to clog
the reed with uny neccessary oily residue.
I look forward to your opinions, and thank you for them.
Kind Regards, john