SOLD HUSKY 180s/280s/380s/280cd/380cd/480cd/380k/480k PISTON+CYLINDER

[JohnnyBlade]

Like title states. Has a few broke fins on top. Had small chip in plating on top of exhaust bevel. Cleaned with sand paper and hit the whole cylinder with red scotch brite on a drill. Smooth bore. 52mm. From what ive gathered this is from the 70's. Either a diamond in the rough or a bastard saw with a used gasket. going out on a limb. Lets say $25 FnF or add 3%. Plus shipping.

 

[JohnnyBlade]

More pics.

 

[Marshy]

More pics.View attachment 207994View attachment 207995View attachment 207996View attachment 207997

That 52mm cylinder fits more than you realize. Straight from a Husky manual on that series of saws....

 

[JohnnyBlade]

That 52mm cylinder fits more than you realize. Straight from a Husky manual on that series of saws....
View attachment 208025

Good deal, thanks for that info @Marshy

 

[JohnnyBlade]

Ok so digging through parts i believe i found the piston for this jug. Had 2 spots on intake side that wer scratched. Pointed out with pics. I wouldnt even call it scored. I lightly sanded the whole piston with red scotch bright to clean it up. Id run the heck out of it. No rings. Included is roll pin and 1
cir-clip. Nothing extra, same price.

 

[JohnnyBlade]

Price reduced to sell.

 

[JohnnyBlade]

So after some interest in this and looking at my original post i feel i didnt FULLY disclose ALL
Flaws. The cylinder has some wore plating below the intake port. It shows in the original pics but may appear as a larger glare that might go unnoticed if u dont know what ur looking for. Not trying to hide anything just getting this out there.
Original picpic with different lighting.