Recent content by Daniel Engel

Interesting. I'll have a look. Thanks!

Sorry for the delay. Things have been kinda crazy lately. Sooo, I put all the new parts in with little to no change in how it runs. It seems to be fine(ish) when the saw is cold, but becomes less cooperative when it warms up. I went back and vac/pressure tested again, and it passed. I'm...

Try doing a resistance test on the coil

Late 90's?

Hey folks, I'm looking for a project to keep me busy after work. A non-running, 60-some cc Jonsered would suit me well. Let me know what you have. Thanks!

Does it have good compression?

Ok, got parts ordered and should be here Weds. I'll let you know how it works out. Thanks for all the input!

Excuse me while I nurse my ego

Aaand, I'm an idiot. The other is a bushing for the chain brake handle :/

This is the book I'm using

In the same book? Interesting...

I wish! I haven't had a chance to even run the saw yet! I bought it as a non-working unit and have slowly been picking away at it.

Also, why does the IPL give me two different part numbers for the same crank sleeve? 503 77 91-01 503 96 70-01 Or, if there is a difference, what are they? I cannot tell....

The washer was in place. Lemme see what I can do about a picture. It's pretty graphic, be forewarned...