High Quality Chainsaw Bars Husqvarna Toys

Search results

  1. D

    362XP idle issues

    Interesting. I'll have a look. Thanks!
  2. D

    362XP idle issues

    Sorry for the delay. Things have been kinda crazy lately. Sooo, I put all the new parts in with little to no change in how it runs. It seems to be fine(ish) when the saw is cold, but becomes less cooperative when it warms up. I went back and vac/pressure tested again, and it passed. I'm...
  3. D

    084

    Try doing a resistance test on the coil
  4. D

    WANTED Jonsered project saw

    Hey folks, I'm looking for a project to keep me busy after work. A non-running, 60-some cc Jonsered would suit me well. Let me know what you have. Thanks!
  5. D

    08S Stihl Firing - Will Not Run

    Does it have good compression?
  6. D

    362XP idle issues

    Ok, got parts ordered and should be here Weds. I'll let you know how it works out. Thanks for all the input!
  7. D

    362XP idle issues

    Excuse me while I nurse my ego
  8. D

    362XP idle issues

    Aaand, I'm an idiot. The other is a bushing for the chain brake handle :/
  9. D

    362XP idle issues

    This is the book I'm using
  10. D

    362XP idle issues

    In the same book? Interesting...
  11. D

    362XP idle issues

    I wish! I haven't had a chance to even run the saw yet! I bought it as a non-working unit and have slowly been picking away at it.
  12. D

    362XP idle issues

    Also, why does the IPL give me two different part numbers for the same crank sleeve? 503 77 91-01 503 96 70-01 Or, if there is a difference, what are they? I cannot tell....
  13. D

    362XP idle issues

  14. D

    362XP idle issues

    The washer was in place. Lemme see what I can do about a picture. It's pretty graphic, be forewarned...
  15. D

    362XP idle issues

    @beaglebriar I tore the saw down to the crank seal, and what I found was disheartening at best. The oiler drive gear was melted and stuck in place, the o-ring between the sleeve and bearing was missing (disintegrated), and the lip of the seal was chowdered. It looks like I over-heated the damn...
  16. D

    362XP idle issues

    Ok, so it failed on vacuum, and only failed on pressure during a revolution of the crank. Soaped up the crank seals, and the clutch side is leaking like crazy. It burns me bc they're brand new! And yes, I did replace the little o-ring nd the crank side sleeve. Time to look into hauling it out...
  17. D

    362XP idle issues

    I'll run to work in a bit for my low pressure regulator and let you know how I make out
  18. D

    362XP idle issues

    And that's why I ask the smart people :)
  19. D

    362XP idle issues

    I popped the vent out and soaked in in carb cleaner, re-installed and tested. That seems to be fine.
Top