dieselfitter
Pinnacle OPE Member
Stihl MS064 with 24" and 32" bars and 5 chains. The previous owner used it for milling and due to health conditions, was no longer able to start it. The 32" bar is a Stihl Rollomatic 3/8"-.050"(like new). The 24" bar is an Oregon 3/8"-.063". The chains are an assortment, Oregon LGX 32"(new), Oregon ripping chain, semi-chisel chain ground for milling... The saw starts 3rd pull and runs good. It is an earlier 064, it has the magnesium air filter cover. It has the normal worn paint from use. I don't see any cracks in the case or covers, no epoxy repairs. It looks to be unmolested, just normal wear.
If any of you have run Andy's/Dodgegeeks 064 ported by Treemonkey, you would want this saw and have it sent directly to Scott for porting. I was going to have Treemonkey port it and keep it. I already have a 288xp ported by Treemonkey and cannot justify ownership of two saws in this size.
Thanks, Tim
If any of you have run Andy's/Dodgegeeks 064 ported by Treemonkey, you would want this saw and have it sent directly to Scott for porting. I was going to have Treemonkey port it and keep it. I already have a 288xp ported by Treemonkey and cannot justify ownership of two saws in this size.
Thanks, Tim