Walmart Poulan 3314?

[67L36Driver]

What’s the initial setting L & H mix screws on the carb?

 

[S Sidwell]

Try 2 to 2.5 rounds out. Finicky saws to set

Steve from my moto g(7) play using Tapatalk

 

[Stevetheboatguy]

On those I found they flood out extremely easy. Quickest way I've been able to get one tuned is by closing the high speed needle down and opening the low to three turns. Get it started and the idle set then open the high speed to three turns and turn it in until it cleans up in the cut.

Might not be right but it works.


Steven

 

[67L36Driver]

Try 2 to 2.5 rounds out. Finicky saws to set

Steve from my moto g(7) play using Tapatalk

Both at 2.5-3 ?

My goodness! [emoji43]‍[emoji94]

 

[Gullet]

I'd try 1.5 turns out from seated.
Go from there.

 

[Guido Salvage]

Carl, you can do better than this saw…

 

[67L36Driver]

Carl, you can do better than this saw…

Quick flip. Lure in customers.

[emoji48]

 

[S Sidwell]

Both at 2.5-3 ?

My goodness! [emoji43]‍[emoji94]

Yep. Strato saws tune a little different cause of the extra air intake on top of carb. I like the saws with catalytic converters in the mufflers, a lot easier to cut those out and retune

Steve from my moto g(7) play using Tapatalk