SOLD Trade New Jonsered branded 24" bar

[jk14]

Brand new Jonsered branded 24" 3/8 .058 84dl. RSN bar, that I believe is D009 mount.

Looking to trade for an 18" lightweight bar in stihl mount, preferably 3/8 .050. Need it for my ms261.

Thanks
Jeff







All lettering on bar is there despite the way the second picture looks, I forgot to turn the flash off.

 

[Czed]

Oregon powermatch/powercut for those that don't know.

 

[timg]

Jeff, Would you sell the J- Bar outright?? Shipping to 16143. PMme if so. Thx. Tim

 

[Orangeinthebarn]

I would just use a regular Stihl Bar on your 261. I had a 261 with a 18 es 3/8 bar with skip chain. That’s how guy before me set it up. If I went back to the 261 I would run .325 18 on a regular stihl e bar. In my opinion it want pull 18 3/8 full comp good if it’s a stock saw. I have ran 63ps60 16 inch and it cut good but pinched bad if doing anything from an angle

 

[jk14]

I would just use a regular Stihl Bar on your 261. I had a 261 with a 18 es 3/8 bar with skip chain. That’s how guy before me set it up. If I went back to the 261 I would run .325 18 on a regular stihl e bar. In my opinion it want pull 18 3/8 full comp good if it’s a stock saw. I have ran 63ps60 16 inch and it cut good but pinched bad if doing anything from an angle

I had a stock muff. modded 261 that pulled 18" full comp. 3/8 fine, and this saw is not gonna be stock. It's heading out to be tickled very soon, it might need .404 when it comes back


Edit: I've got one of these on the way.

 

[Czed]

I had a muff. modded 261 that pulled 18" full comp. 3/8 fine, and this saw is not gonna be stock. It's heading out to be tickled very soon, it might need .404 when it comes back

those oregon versacut are very light.
laminate bar's though.