SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl

[Duane(Pa)]

Like new Sugi. Fits small mount husky and others. I drilled the oil hole slightly larger diameter. $75.00 I actually have two of these bars to move along. Buy both and I will cover shipping LMK. DW

 

[Duane(Pa)]

Make an offer. I'm going .325 on everything under 20"

 

[cuinrearview]

Have these been milled/modded to Stihl specs or what?

 

[Duane(Pa)]

Have these been milled/modded to Stihl specs or what?

No. They are SMH unmolested. Pretty sure I went 3/16 on oil hole.

 

[Duane(Pa)]

Make an offer and BUMP

 

[cuinrearview]

I have one of these on my ported red 346. Feels like the perfect fit and balance. With an eight pin rim it's a hell of a firewood slaughterer.

 

[Duane(Pa)]

Fry day bumpers

 

[Shane¹]

Couldn't you just put a .325 tip on them? Wouldn't it be cheaper than getting new bars?

 

[Duane(Pa)]

Couldn't you just put a .325 tip on them? Wouldn't it be cheaper than getting new bars?

Might come down to that. Depends on width of nose and I suspect the 3/8 bar may be slightly wider.
I’m slightly baffled by the lack of market for saw blades in general. Running outta nails to hang them on

 

[singinwoodwackr]

Might come down to that. Depends on width of nose and I suspect the 3/8 bar may be slightly wider.
I’m slightly baffled by the lack of market for saw blades in general. Running outta nails to hang them on

Get longer nails

 

[Junk Meister]

Get longer nails

GET MORE NAILS!! AND LONGER ONES Whilst yer at it..

 

[singinwoodwackr]

GET MORE NAILS!! AND LONGER ONES Whilst yer at it..

9"?

 

[Junk Meister]

9"?

GONNA have to be finish nails or grind the head to accept the bar slot. But YUPP.

 

[singinwoodwackr]

GONNA have to be finish nails or grind the head to accept the bar slot. But YUPP.

Right over your head, lol...

 

[Woodslasher]

9"?