SELLING Stihl MS650 Cylinder and Piston new

[ManiacalMark]

Brand new, not sure where the box went
$320 shipped

 

[ManiacalMark]

$300 shipped

 

[ManiacalMark]

$250 shipped, paid almost $400

 

[EFSM]

Maybe you should give a sales pitch? I understand this is the small bore version of a 660 p&c. Are there any advantages to it other than increased longevity?

 

[Stump Shot]

Maybe you should give a sales pitch? I understand this is the small bore version of a 660 p&c. Are there any advantages to it other than increased longevity?

They are a porters dream, everything lines up nicely with the lathe work, unlike the bigger 660 cylinder which can be all over the place.

 

[Hinerman]

They are a porters dream, everything lines up nicely with the lathe work, unlike the bigger 660 cylinder which can be all over the place.

Is it a direct fit on an 064?

 

[Stem]

Is it a direct fit on an 064?

064/early 066 is narrower bolt pattern

 

[Stump Shot]

Is it a direct fit on an 064?

064/early 066 is narrower bolt pattern

Has to be massaged to fit I believe.

 

[Stem]

Has to be massaged to fit I believe.

it is doable, i think the difference is 5mm in width, If I remember correctly. length wise its the same.

 

[ManiacalMark]

Have to slot the mounting holes for an 064. Have my other 650 cylinder machined and ported ready for my 064. Thicker base is a plus for me.